Product category: adhesive hook Material: stainless steel Style: single hook Maximum load: 3 kg [High quality material]: The hook is made of food grade 304 stainless steel, with wire drawing treatment, and the surface has anti-corrosion coating, which can resist daily scratches and ensure its durability. Water and oil resistant, no traces. [Towel hook with modern design]: A base and a cylinder form a clothes hook, which allows it to support a certain weight. The simple and elegant towel hook can be perfectly combined with many decorations in modern style. [Easy to install or dismantle]: No need to drill, strong adhesion and waterproof. Peel off the protective layer of adhesive and stick the hook on a smooth surface; installation only takes a few seconds. Simply heat the self-adhesive with a hair dryer to remove it. 4 Piece Sticky Hook, Wall Mounted Towel Rack Hook, Stainless Steel Bathroom Hook, Water and Oil Proof Self Adhesive Hook for Kitchen, Living Room and Office [Scope] : This hook is suitable for smooth surfaces such as glass, mirrors, tiles, metal surfaces, etc. It is very suitable for bedrooms, bathrooms, toilets, closets, kitchens and offices, etc. Instructions for use It is recommended to regularly clean the surface of the product with water or a mild detergent, then dry it with a soft towel. To keep the look shiny and clean, do not use detergents based on salt and vinegar. Avoid hard objects scratching the surface of the product, do not wipe with a rough cloth, it is recommended to use special maintenance wipes for cleaning. Do not come into contact with organic solutions and corrosive chemicals, and use it in a gaseous environment with the above substances, so as not to damage the surface coating and affect the brightness of the coating. This product is suitable for installation after the decoration project is completed to prevent product damage and corrosion. Damage to quality caused by the use of this product which does not comply with the above directives will be the responsibility of the user. Installation steps: Clean and dry the wall, taking care not to leave dust, grease or wax on the surface. Before installation, please mark the desired location of the product on the wall. Apply glue to the metal area on the back of the product. Remove the protective film from the double-sided adhesive tape. Press the rear part against the marked position for 3 to 5 seconds. Use self-adhesive supplement without nails to secure the product. For best results, please wait 3-5 dbefore use. Note: Do not apply this product to whitewashed, wallpapered, lime-covered walls, or other soft or uneven surfaces. Tips from the store: 1. The size is manually measured, please allow the error (1-3cm). 2. Due to the different monitor pixels, there may be some color difference, please refer to the actual product.