Specification: Power: 18W. LED Chips Type: SMD2835. Beam Angle: 120 deg. Power rating: AC12V. Frequency: 50~60Hz. Waterproof: IP68. Installation Location: 0.6M below water level. Cable Length: 135cm. Remote Control: Within the scope of 50m. Features: 252Pcs 2835 lamp beads LEDs with super bright and crisp colors. Can be switched on and adjusted by a remote RGB controller for convenience. Plastic housing makes it acid-proof and alkali-proof. Supports 15 different kinds of color styles. The lamp is filled with resin inside, which makes it 100% waterproof. Easy to install, fitting to standard pool fittings. Compatible for both fresh or salt water pool. Remote Control Operation: ▶ ON/OFF: Power switch function,press the key for turning on or turning off the light. ▶ MODE: Modes selection,the light can be turned to the first program when press this key for 5 seconds at any working program. ▶ 15 pre-programmed color modes of RGB light. 1.R-G-B change gradually to full modes. 2.RG: Static State Yellow. 3:RB: Static State Purple. 4.GB: Static Cyan-Blue. 5.RGB-RG-G-GB-B-R animation 6.RB-GB-B animation. 7.R-G animation. 8.B-R animation. 9.G-B animation. 10.RB-B animation. 11.G-GB animation. 12.R:Static State Red. 13.B:Static State Blue. 14.G:Static State Green. 15.RGB:Static State White. ▶ B+/B-: Adjust the brightness of the light at any working program,there are total 10 adjusting levels. ▶ S+/S-: Adjust the color changing speed,there are total 10 adjusting levels. Note: You will need a AC12V transformer to power the lights. If more than AC12V, it will damage the light. Package Included: 1 x LED Light. 1 x Remote Control (1x  Battery 23A/12V Not Inculude ). 1 x Waterproof Connector