Function: 1. Auto transfer: When the normal power is abnormal, the switch will automatically switch to standby power so it works immediately. 2. Continuous power: This switch can be flipped in milliseconds without interruption, which ensures continuity, reliability and safety of the power supply. 3. Robust structure: This automatic transfer switch has the features of solid structure, reliable conversion, convenient installation and maintenance, and long service life. 4. Premium material: silver contact improves the conductivity and service life of the switch, and the flame-retardant PC shell has good insulation, high temperature resistance and anti-aging. 5. Wide application: This switch can be widely used in various places where continuous power failure is not allowed, such as factories, shopping malls, nurseries, etc. AUTOMATIC POWER SWITCH 2P AC230V 63A Specification: Item Type: Automatic Transfer Switch Material: PC and silver Model: CHLT 125 2P Insulation voltage: AC690V Rated voltage: AC400V Coil voltage: 230VAC Level: PC level Specifications: 2P Life: Electric: 2000 times Mechanical: 5000 times Rated short-circuit current: 50kA Fuse: RT16-00-63A Rated impulse withstand Voltage: 8kV Control circuit: Rated control voltage Us: AC220V 85% Us-110% Us Auxiliary circuit: two relays each with two sets Contact capacity: AC220V50HZ le = 5y Touch time: andlt;50ms Operation transition time: andlt;50ms Return time: andlt;50ms Shutdown time: andlt;50ms Package List: 1 x Automatic Transfer Switch 1 x Manual Note: 1. The maximum ambient temperature should not exceed 40 ℃, the minimum temperature should not be lower than -5 ℃, and the average temperature in 24 hours should not be higher than 35 ℃ 2. The height of the installation site should not exceed 2000m 3. When the maximum temperature reaches 40 ℃, the relative humidity of the installation site should not exceed 50%; when the temperature is the lowest temperature -5, the relative humidity is higher, for example, if the temperature is 25 ℃, the relative humidity is 90%. Special measures must be taken to deal with the occasional condensation on the surface of the product due to temperature changes Check the integrity of the ATS before installation, turn the ATS on or off with the operating lever, check the transmission flexibility and detect normal and backup load generation and disconnection conditions at each stage