Cautions: If the new device cannot be remote controlled, check whether the bar codes in the emitter and receiver are consistent, whether the indicator light on the emitter is working, whether the receiver cable is properly connected, and whether the buzzer beeps once when powered on. If the receiver cannot be controlled by the emitter, check whether the battery contact is normal and whether the power is sufficient. Replace the battery promptly when it is low. Insensitive remote control may be due to environmental interference or low battery. Remove the battery if the device is not used for a long time. Wire strictly according to the parameters listed on the labels. Failure to do so may shorten the device's lifespan or cause immediate malfunction. The antenna must not be connected to other wires. If there is a code switch on the fan, set the fan to the highest speed before remote operation. The receiver emits a beep when the remote is pressed, which may be noticeable. Ensure there is enough space in the fan canopy or position the receiver accordingly. Operating Voltage: AC 90-220V Working Frequency: 50-60Hz Remote Control Distance: More than 20 meters Support Encoding: 1527 learning code Operating Mode: 1527 remote control Loading Power: Ceiling Fan: Max. 300W Incandescent Lamp: Max. 1000W LED / Energy-saving Lamp: Max. 200W LED Light / Energy-saving Lamp: Max. 200W Do not overload! Remote Control Battery: 2 AAA batteries required (Not Included) Type: 220V/110V Color: White + Black Material: Plastic Package Contents: 1 x Controller 1 x Remote Control 1 x Wall Mount Only the above package content, other products are not included. Note: Lighting and display differences may cause slight color variations between the image and the actual item. Measurement error allowance is +/- 1-3 cm.