Specification: Operating voltage: DC 12 V-36 V Operating current: Driver power: Speed voltage: 0,1 V-5 V Operating temperature: -40-85C Humidity: 90% relative humidity Drag protection: yes Enable Control: Yes Overcurrent protection: yes Steering Control: Yes Speed Control Signal: Yes Size: 63*42*17mm (L *width *height ); Probe size 3mm, length: distance from center of mounting hole 57mm; width: constant distance from center of hole 36,5 mm Power Output: VCC (Positive Power Supply) GND (negative) MC(Engine phases W) MB(Engine phase V) MA(U engine phase) Set on the control side: Weight of GND control clamp VR end of regulator 0-5 V (corresponding to 10% motor speed -100%) ZF reversing control (connected do 5 V or grounding can charge the direction of rotation of the motor) M tachometer pulse output (depending on the number of motor poles corresponding to the number of pulses per output number rotation) EL switch-on control terminal (connected do 5 V or grounding, then 5 V, motor grounding stops) Control Clamp 5V 5V HALL dla indoor terminals: 5 V. Positive room power Ha Signal Halla Hb Halla signal Hc room signal GND Hall negative Wiring: Control terminal dla SET: 1. Motor speed control wiring methods: the available potentiometer system speed can also be connected do MCU control,when the potentiometer control wiring, the middle contact of the potentiometer is connected do VR speed port,potentiometer connected do both ends of voltage 5 V and voltage of terminals GND higher speed, faster. 2. Motor control wiring methods: control can be switched, they can also be connected do MCU control, do GND in one direction, then in one 5V direction. 3. Pulse speed signal: high and low output signal. IC cannot understand the information contained in the client request. Halla dla Halla signal inputs: The connection diagram is shown, one corresponding to HA, HB, HC and on the engine, the 5 V power supply connected do half of the engine signals positive GND power signals, negative signal do of the engine hall. Note: Due to different engine manufacturers, the order of the lines in the hall does not necessarily have to be consistent with the line on the board, to match it do sequence, it should be adjusted, please parents who pay attention! If the order of the line is incorrect, does not start properly, the current or other phenomena do not start, the forced do use drive plate will burn!!! Motor driver board 12 to 36V DC power input, VCC positive power supply, GND power supply is negative. Electrical wiring methods: Brushless DC motor dla three lines, corresponding to MA/U, MB/V, MC/W Advice: If you use less than 60W, without additional heat sink, be sure to add more than 60W Heatsink ribs increase efficiency without lowering the temperature. Too high a temperature will cause permanent damage! The size of the heat sink may be due to poor environment (recommended cooling area greater than 200 square centimeters)! When installing the heat sink, pay attention to the rear part of the insulation of the MOS pipe of module 6, no insulation, it will be glued do of the drive plate permanently damaged! I suggest adding insulation films, both sides of the insulation sheet plus thermal paste! The package includes: 1x12-36 V 500 W Brushless Motor Driver