ESP32-DevKitC-32E WIFI+Bluetooth Development Board Equipped With ESP-32E Module CP2102 Driver Chip Micro USB Interface 38 Pin _x000D_ Features: 1. Adopting a small development board design, with complete pin connections, it is easy to connect peripheral devices or insert into breadboards for use. _x000D_ 2. Integrated Wi Fi (802.11b/g/n) and Bluetooth functions, supporting high-speed wireless communication and multiple protocols. _x000D_ 3. High data rate, supporting A-MPDU, A-MSDU aggregation and 0.4 μ s protection interval, with superior performance. _x000D_ 4. Supports USB-UUART bridge, with a maximum transmission rate of 3 Mbps, and supports firmware download and debugging. _x000D_ 5. Equipped with reset and download buttons, integrated 5V power indicator light and multifunctional I/O interface, easy to use. _x000D_ Description: _x000D_ ESP32 DevKitC is a small development board, with most of the pins of the modules on the board already led out. Developers can easily connect various peripheral devices through jumpers according to their actual needs, or plug the development board into a breadboard for use. _x000D_ Parameters: _x000D_ ESP-32E: Onboard PCB antenna _x000D_ Driver chip: CP2102 _x000D_ • 802.11b/g/n _x000D_ Data rates up to 150 Mbps in 802.11n mode _x000D_ • Support A-MPDU and A-MSDU aggregation _x000D_ 0.4 μ s protection interval _x000D_ • Working channel center frequency range: 2412~2484 MHz _x000D_ Bluetooth V4.2 BR/EDR and Bluetooth LE standards _x000D_ CVSD and SBC _x000D_ •Flash：4MB _x000D_ EN: Reset button. _x000D_ Boot: Download button. Press and hold the Boot key, while pressing the EN key (do not release the Boot key at this time) to enter the "firmware download" mode and download firmware through the serial port. _x000D_ USB to UART Bridge: A single-chip USB-UUART bridge that can provide transmission rates of up to 3Mbps. _x000D_ Micro USB interface: A USB interface that can be used as a power supply for circuit boards or as a communication interface for connecting PCs and ESP modules. _x000D_ 5V Power On LED: After the development board is powered on (USB or external 5V), this indicator light will light up. _x000D_ I/O: Most of the pins of the module on the board have been led out to the pin bank of the development board. Users can program ESP32 to achieve various functions such as PWM, ADC, DAC, I2C, I2S, SPI, etc. _x000D_ • Power options: _x000D_ The development board can choose one of the following three power supply methods: _x000D_ 1. Micro USB power supply (default) _x000D_ 2. 5V/GND pin power supply _x000D_ 3. 3V3/GND pin power supply _x000D_ Attention: The above power supply modes cannot be connected simultaneously, otherwise it may damage the development board and/or power supply. _x000D_ Package included: _x000D_ 1 x ESP32-DevKitC-32E WIFI+Bluetooth Development Board Equipped With ESP-32E Module CP2102 Driver Chip Micro USB Interface 38 Pin _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_