Processor: SG2002 processors; Integrated CVITEK TPU for smart detection Like neural networks hardware accelerators, AI image recognition. Supports 264/265 video encoding, up to 2880x1620@20fps.Compatible with high-definition CMOS sensors. Programmable frequency output for sensor clock.Comprehensive ISP features for image optimization.Partial OpenCV library support with CV hardware acceleration. 16-bit audio codec with built-in mic input and output functions.Flexible network configurations with 1 Ethernet PHY. Different batches may have different appearances, but will not affect the use Note: The PCB Color shipped Randomly. Do not Order if you mind. This is a Linux Board , You can not run it On Pico IED his board only refers to the GPIO pinlayout of RPi PICO to be Compatible with PICO expansion boards. It is different from PICO and cannot share PICO software. Overview: Milk-V Duo 256M is an ultra-compact embedded development platform based on the SG2002 chip. It can run Linux and RTOS, providing a reliable, low-cost, and high-performance platform for , industrial ODMs, AIoT enthusiasts, DIY hobbyists, and creators. Specification: Processor : SG2002 Memory : DDR2 256MB Storage : 1x Mirco SD slot,1x SD NAND solder pad USB : 1x Type-C for data and Power,1x USB2 solder pad Camera : 1x 16P FPC connector (MIPI 2-) GPIO : up to 26 Pins available for I/O(GPIO) Size : 21mm x 51mm Board Specifications Single-sided PCB Dimensions: 51x21mm Thickness: 1mm Type-C port located on the top edge Dual castellated/through-hole pins around the remaining edges Can be used as a mount module or in Dual Inline Package (DIP) format 40 main user pins on a 2.54mm (0.1inch) pitch grid with 1mm holes Compatible with veroboard and breadboard Colour:random color , don't accept the specified color Material:PCB Package Contents: 1 x Milk-V-Duo-256M Board Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.