Automatically charge the battery. The rectifier and brake circuit of this controller adopts an integrated module, offering improved heat dissipation and reliability compared to traditional designs. Features a fully sealed and waterproof design with a protection rating of IP67, allowing for long-term normal operation even when submerged in water. Note: Ensure the output voltage of the wind turbine generator matches the rated voltage of the battery. Connect the wires in the following order: first connect the positive and negative terminals of the battery, then connect the three-phase output of the wind turbine. Always connect the battery and wind turbine to the controller according to the instructions. Reversed polarity or incorrect connections may result in system malfunction or permanent damage to the controller. Wiring instructions: 1. Connect the positive and negative terminals of the battery to the corresponding positive (red) and negative (black) battery terminals on the controller. 2. Connect the three-phase output of the wind turbine to the three-phase input (green wires) on the controller. Specifications: - Maximum input AC voltage: AC35V - Output voltage: 12V / 24V - Battery charging cut-off voltage: 14.5V ± 0.3V / 29V ± 0.3V - Maximum charging current: 15A (12V), 10A (24V) - Wind generator speed limit voltage: 14.5V ± 0.3V / 29V ± 0.3V - Protection level: IP67 - Static power consumption: 0.008A - Bearing power: 800W - Maximum bearing wind speed: 12 m/s - Operating temperature: -35°C to 65°C - Input wiring: Three-wire system - Control mode: Compatible with 12V and 24V systems - Installation: Bolted - Do not reverse the positive and negative terminals to prevent damage to the controller Application: Wind controller Color: Blue Material: Aluminum alloy Package includes: 1 x MPPT Wind Generator Controller Note: Light reflection and differences in display screens may cause slight variations in color between the product image and the actual item. Measurement error allowed within +/- 1-3 cm.