Replacement LCD display and ribbon cable designed for Volvo Penta and Yanmar marine tachometer/hour meter instruments. This direct replacement restores clear engine RPM and hour readings when the original display or flex ribbon fails, without the expense of replacing the entire gauge.Key benefitsRestores visibility and functionality: replaces cracked, faded, or blank LCD and damaged ribbon to bring your tachometer and hour meter back to full working .Costeffective : only the faulty display assembly instead of the whole instrument or boat wiring harness.Simple installation: the included flexible ribbon cable allows straightforward connection to the existing instrument board; suitable for routine maintenance or field repairs.Prevents downtime: quickly regain accurate RPM and runtime monitoring to maintain safe engine operation and service scheduling.What this part includesLCD display module sized for compatible Volvo Penta and Yanmar tachometer/hour meter assemblies.Flexible ribbon (flat flex) cable for connecting the LCD to the instrument circuit board.Key attributesFunctionality: Displays tachometer (RPM) and hour meter information when installed in the correct instrument housing.Compatibility: Engineered as a replacement for Volvo Penta and Yanmar marine tachometer/hour meter displays. Verify physical appearance and connector orientation against your existing unit before .Construction: LCD display paired with a flexible ribbon cable for reliable electrical connection and a compact fit inside the instrument housing.Performance: Restores readable instrument output and enables continued monitoring of engine speed and accumulated hours for maintenance planning.Use casesa Volvo Penta gauge with a cracked or nonresponsive LCD so the skipper can accurately monitor engine RPM during cruising and docking.a faded hour meter display on a Yanmarequipped workboat to restore accurate runtime records used for scheduling oil changes and service intervals.Service a marinaowned demo boat by swapping the display assembly to the tachometer/hour meter to working condition without the entire instrument to a service center.Installation tipsConfirm the replacement display and ribbon match the connector type, orientation, and mounting holes of your existing instrument before installation.Power off the instrument and the vessel's electrical supply before connecting the ribbon to avoid damage.Handle the flexible ribbon carefully—avoid sharp bends or creases and ensure proper alignment to the board connector.Compatible with Volvo Penta and Yanmar marine tachometer/hour meter assemblies; intended as a replacement display and ribbon cable to restore instrument readability and functionality.