Origin:Mainland ChinaRubber Hook Stopper Winch Cable Line Saver For ATV UTV Winches Universal Winch Cable Hook Stopper Rubber Winch Rope Line Saver Feature [Function]: When the winch cable is using, it will cause damage to the winch parts when recovering or sliding the cable since of the speed, bounce and other reasons.This winch cable hook stopper will solve helping you solve them. [Material]: It was made of Rubber. It is elastic that can eliminate the rattling and quivering of the hook cable guide while sliding. [Benefits]: The hook saver prevent the winch motor and gears from pulling the cable in too far and bottoming out on the rollers. Also Keeping tension on the hook to protect the cable from becoming loose. [Easy& Versatile ]: Easy to install,and it can be used on the weight machine to replace the original ball stopper for easy replacement. Instructions 1.Remove the pin of the hook and pull the hook off the cable. 2.Simply install the rope or cable between two and a half parts, and because of the two-piece design, there is no need to use the casing or any lubricant of the wire rope. 3.Insert four bolts and tighten them with the inner hexagonal wrench attached to the box. 4. Put the hook back to the end of the cable or rope. contact the contracting part of the clutch and shaft until the hook is located on the hook and ball. 5.please locate the hook limiter at approximately 3 4 of the hook length when using the winch. Notice: If you are using steel cable, please wear gloves during installation to protect your hands.